Back
Floor-standing bathtub faucet
- D-819 Ceramic Spindle 38H High Foot
- Water outlet height: 870mm
- Water outlet distance: 220mm
- This series of products can be customized according to the project stainless steel wire drawing color
1
Remove the plastic dust cover
2
Please confirm the installation direction and position of the faucet according to the picture below
3
Construct the installation slot on the ground as shown in the figure
4
Use a pencil to mark the drilling position and drill with a Ø10 impact drill
5
Connect hot and cold water pipes
6
After the embedded box is leveled, drive the burst screw into the hole
7
After fixing the embedded box, check the level again
8
Install water testing accessories
9
Turn on the water source and raise the water pressure to 0.8MPa and maintain it for 30 minutes to ensure there is no leakage in the pipeline
10
Turn off the water source and remove the water test accessories
11
Install pipe flushing accessories
12
Turn on the water source and flush the pipes
13
Turn off the water source and flush the water pipe accessories
14
Replace the dust cover
15
Pour cement, lay floor tiles, and break the glass glue between the embedded box and the floor tiles
16
After the floor cement is completely dry, cut off the excess part of the embedded box
